Cooper Security i-on160EX Guide d'installation télécharger pdf (Page 14)

Basic Programming Procedures i-on160

Page 8

ready for use.

If the control unit finds a device missing, or one

with an address that has not been added using

the Installer Menu then the display shows, for

example:

The top line of the display shows the number of

new devices found, and the number of existing

devices missing (lost). The bottom line of the

display shows the first in the list of found and

lost devices.

FOUND 0, LOST 1

Lost R1-03

4. Either: press X to put the control unit back into

Installer Menu (so that you can go and check

that all the bus devices you have installed are

connected, powered up and addressed

correctly).

Note: To check an expander address remove the lid

and briefly press the addressing button. The

two digit display will show the bus address for a

few seconds.

OR: Press Y to make the control unit update its

internal record of devices attached to the bus.

The display shows:

Accept all changes

to bus

5. Press Y to accept the change to the bus. (You

can still press X to return to the installer menu

if you do not want to change the number of

devices on the bus.)

Note: If you attempt to leave the Installer Menu when there is a fault (for

example a detector–, control unit lid–, siren– or keypad tamper is active,

or the battery is missing) then the keypad displays a fault message telling

you which device is causing the problem. Press

to return to the

Installer Menu. You must rectify the fault (or delete the device from the

system) before you can leave the Installer Menu.

Important! Saving Changes

When you make changes to the Installer Menu the control unit holds those

changes in temporary memory until you leave the Installer Menu. As you leave

the Installer Menu the control unit writes those changes into a permanent

store. If you remove all power BEFORE you leave the Installer Menu then the

control unit will lose your changes. Note that this does not apply if you restore

Factory Defaults; that change takes place immediately.

Defaulting the System

If you wish to restore the control unit to its factory defaults then you must do

this from a keypad. You cannot restore factory defaults from a connected PC.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 179 180

Commentaires sur ces manuels

Pas de commentaire

Cooper Security i-on160EX Guide d'installation Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Cooper Security i-on160EX