Cooper Security i-on160EX Guide d'installation Page 81

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 180
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 80
i-on160 Installer Menu Options
Page 75
Report Type
To choose the report type to send to the ARC select: Communications – ARC
Reporting – Report Type.
The report types available are: Fast Format, Contact ID, SIA 1, SIA 2,
Scancom SIA 3, Extended SIA 3.
Fast Format Channels
(See Appendix I for a brief description of Fast Format.)
If you selected Fast Format in Report Type then you can select Communications
- ARC Reporting - Fast Format Channels to allocate one of the following events to
each of eight channels (defaults in brackets):
1. Not used
2. Fire Alarm (default Channel 1)
3. Panic Alarm (default Channel 2)
4. Burglar Alarm (default Channel 3)
5. Open/Close (default Channel 4)
6. Alarm Abort (default Channel 6)
7. Technical Alarm (default Channel 8)
8. Confirmed Alarm (default Channel 7)
9. RF Low Battery
10. RF Supervision (see note 5)
11. RF Jamming (see note 5)
12. Mains Fail
13. Tamper
14. Open (see note 1)
15. Close (see note 1)
16. Zone Omitted - setting (default Channel 5. see note 2)
17. Zone Omitted - system (see note 4)
18. General Fault
19. Masking
20. Burg Partition 1 (partioned system only)
.. and so on up to:
39. Burg Partition 20 (partioned system only)
Notes:1. Open and Close provide the same functions as Open/Close, but on
two separate channels.
2. Zone Omitted - the control unit sends this signal for five seconds when
a user omits a zone.
3. The control unit delays reporting/logging either mains loss, or exiting
Installer Menu with mains loss, by 15-18 min (chosen randomly). For
Scandinavia the control unit waits at least 60 minutes before reporting.
4. Appears only when DD243 options enabled.
5. The control unit communicates Jamming, Supervision when the system
is unset.
Vue de la page 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 179 180

Commentaires sur ces manuels

Pas de commentaire