Cooper Security i-on160EX Guide d'installation télécharger pdf (Page 15)

i-on160 Basic Programming Procedures

Page 9

Note that this procedure deletes all radio detector identities.

Restoring Factory Defaults

1. Enter the Installer Menu.

INSTALLER MENU

Detectors/Devices >

2. Press n until the bottom line shows System

Options:

INSTALLER MENU

System Options >

3. Press Y .

The display shows:

SYSTEM OPTIONS

Wired zone type

4. Press n until the bottom line shows:

SYSTEM OPTIONS

Restore defaults >

5. Press Y .

The display shows:

RESTORE DEFAULTS

Country defaults >

6. Press n until the bottom line shows:

RESTORE DEFAULTS

Factory defaults >

7. Press Y.

The display asks for confirmation.

FACTORY DEFAULTS

Are you sure?

8. Press Y to load defaults.

(Press X to go back to the Installer Menu

without changing defaults.)

The display asks you to select Partition Mode or

Part Set Mode. (See page 4.)

A : Partition mode

B : Part set mode

9. EITHER: Press A to create a partition based

system.

OR Press B to create a part setting system.

The display asks you to select the Security

Grade. (See page 5.)

SYSTEM GRADE

*Grade 3

10. Press u or n to select either Security Grade 3

or Security Grade 2 settings.

Note: If you change Grades then the keypad display

reminds you that all user codes will be

defaulted.

(If you change your mind at this point and do

not wish to default user codes then press

stay with the current security grade.)

Press Y to confirm your selection.

The display asks you to select the zone wiring

type. (See page 60.)

WIRED ZONE TYPE

*2-wire FSL 2k2/4k7

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 179 180

Commentaires sur ces manuels

Pas de commentaire

Cooper Security i-on160EX Guide d'installation Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Cooper Security i-on160EX