Cooper Security i-on160EX Guide d'installation télécharger pdf (Page 54)

Installer Menu Options i-on160

Page 48

Type: Active when: Assign to

Partitions?

Panel Battery

Fault (13)

The control unit detects a fault with its

backup battery, OR a zone of type

“External PSU Battery Fault” has been

triggered. If the alert was caused by an

“External PSU Battery Fault” zone then the

control unit deactivates the output when

the zone has been restored and a user has

acknowledges the fault by entering a valid

access code.

If the alert was caused by a fault with the

control unit’s backup battery then the

control unit deactivates the output when it

detects a good battery and a user

acknowledges the alert.

Note: To cause the control unit to check its

backup battery enter and leave the

Installer Menu.

External PSU

Low Volts (14)

An external power supply has tri

ered an

External PSU Low Volts zone.

The control unit deactivates the output

when the zone has been restored and a

user has acknowledges the fault by

entering a valid access code.

External PSU

Fault (15)

An external power supply fault signal

triggers a Power output fault zone.

The control unit deactivates the output

when the zone has been restored and a

user has acknowledges the fault by

entering a valid access code.

Tamper (16) The control unit detects tamper on any the

following devices:

Control unit, lid or wall tamper.

Radio or wired keypad.

Zone type “Tamper” activates.

Detectors or Expanders

Sounders

The control unit deactivates the output

when tamper is reset.

Yes

Zone Omit

(Setting) (17)

The user Omits a zone while setting the

system. The output deactivates when the

control unit restores the zone.

Yes

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 179 180

Commentaires sur ces manuels

Pas de commentaire

Cooper Security i-on160EX Guide d'installation Page 54

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Cooper Security i-on160EX